i have a little problem with my geigercounter kit here.
Well, i soldered everything and wanted to test the kit, but i don't get any sound, LED flash or welcome message over the serial port.
i double checked the components and the direction of the parts that go only one way. This shouldn't be the problem, everything is in place as it should be.
Also i checked the soldering points(well, i'm not very good in soldering) but they look good to me. If i check from the down left point of the battery dock, i get about 3V at every point of the board(from r1 to the last pin of the microprocessor).
Any ideas what could possibly be wrong? Thanks