Support forum for the mightyohm.com Geiger Counter.
4 posts • Page 1 of 1
I was able to program a attiny2313 by using a arduino as serial programmer and AVRdude. I struggled with getting the right command. I needed to add -b19200 for the baud serial communication. It was not clear to me in all the tutorials I read. I now have a working Geiger counter!
Make sure you set the configuration fuses as specified in Makefile.
Code: Select all
# Fuse configuration: # For a really nice guide to AVR fuses, see http://www.engbedded.com/fusecalc/ # LFUSE: SUT0, CKSEL0 (Ext Xtal 8+Mhz, 0ms startup time) LFUSE = 0xEE # HFUSE: SPIEN, BODLEVEL0 (Serial programming enabled, Brownout = 1.8V HFUSE = 0xDD # EFUSE: no fuses programmed EFUSE = 0xFF