Everything was going well (Music playing and LCD display functioning) until...
I desoldered my power, USB header and sound card USB as displayed int he images in step 10 and I am now I'm getting an error connecting the usb sound card.
On boot the error messages are displayed below. I'm using a Asus WL520GU and the SYBA USB sound card.
I have tried reimaging the router with OpenWRT (the image provided on Jeff's instructions)
I tested the USB sound card in a different computer see if it works and it does.
I thought maybe I fried something while desoldering but I get the same results on two different routers (both desoldered) and two different sound cards (also desoldered). I'm not a soldering expert but I took my time and the vias look good. I test for continuity and the connection appear to be good.
Any ideas on what I did wrong?
*** Edit, I'd also like to add I'm getting 4.7v between red and black on the USB sound card but no lights
usb-ohci.c: USB OHCI at membase 0xb8003000, IRQ 6
usb-ohci.c: usb-00:03.0, PCI device 14e4:471a
usb.c: new USB bus registered, assigned bus number 1
hub.c: USB hub found
hub.c: 2 ports detected
usb.c: registered new driver audio
audio.c: v1.0.0:USB Audio Class driver
hub.c: new USB device 00:03.0-1, assigned address 2
usb.c: USB device not accepting new address=2 (error=-145)
hub.c: new USB device 00:03.0-1, assigned address 3
usb.c: USB device not accepting new address=3 (error=-145)
Discussion about my Wifi Radio project at http://mightyohm.com/wifiradio/ or my WL-520gU talk at NOTACON.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests