Page 1 of 1

How can I adapt the HV Rescue Shield for an ATMEGA2560

Posted: Mon Jan 13, 2014 5:37 pm
by pkup
Hi,

I would like to be able to reset fuses on my ATMEGA2560 Arduino R3 board?

Can any one share ideas on how this can be accomplished with the HV Rescue Shield 2?

Thanks,
Paul K.

Re: How can I adapt the HV Rescue Shield for an ATMEGA2560

Posted: Sat Jan 18, 2014 5:11 pm
by mightyohm
That's an interesting idea but it sounds pretty challenging. The ATMEGA is soldered to the Arduino so it can't easily be removed for programming. You could try wiring individual signals from the Rescue Shield to the ATMEGA, but the Rescue Shield needs to cycle power to the AVR during programming, and that would be hard to do with the rest of the Arduino connected!

Re: How can I adapt the HV Rescue Shield for an ATMEGA2560

Posted: Sun Apr 23, 2017 2:46 am
by andrei777
please can you show me wirings for an atmega 2560,
it is a prototype board and i removed all components,
i have only 2560 soldered on the board and all free pins.
thank you.

Re: How can I adapt the HV Rescue Shield for an ATMEGA2560

Posted: Mon Apr 24, 2017 2:28 am
by andrei777
http://www.atmel.com/Images/Atmel-2549- ... asheet.pdf

at page 329 is paralel programing, ...

Re: How can I adapt the HV Rescue Shield for an ATMEGA2560

Posted: Tue Apr 25, 2017 8:02 pm
by mightyohm
Which version of the kit are you using?