Board mod

Support forum for the mightyohm.com Geiger Counter.
http://mightyohm.com/geiger
Post Reply
hashosaf
Posts: 2
Joined: Fri Jun 26, 2015 12:59 pm

Board mod

Post by hashosaf »

hello everybody.

i have two questions.
1. i want to use geiger board with arduino. So do i have to use attiny 2313, is there any problem when connect TP1 pin to arduino directly.
Image

2. I couldn't find fjn3303f transistor. Is there any transistor which using fjn3303n places. If the answer no can anybody sell me on ebay.

Thank you for all my friends ...
User avatar
mightyohm
Site Admin
Posts: 1064
Joined: Fri Apr 03, 2009 10:29 pm
Location: Seattle, WA
Contact:

Re: Board mod

Post by mightyohm »

What power supply do you plan to use for the geiger counter? Batteries or the Arduino 5V?

What country do you live in? The FJN3303 is available in the US. I'm not sure if it's available outside the US but Farnell may carry it.
hashosaf
Posts: 2
Joined: Fri Jun 26, 2015 12:59 pm

Re: Board mod

Post by hashosaf »

İ want use arduino for power supply with 5 v if you have fjn3303 i can buy from you with ebay
User avatar
mightyohm
Site Admin
Posts: 1064
Joined: Fri Apr 03, 2009 10:29 pm
Location: Seattle, WA
Contact:

Re: Board mod

Post by mightyohm »

hashosaf -

I do not sell parts on ebay, but there are several sources for the FJN3303F here: https://octopart.com/search?q=FJN3303F&start=0

This post has some instructions on how to connect the kit to Arduino: http://www.mightyohm.com/forum/viewtopi ... iger#p5730

The easiest way is to use the PULSE output (J6 pin 2) instead of TP1.
Post Reply