Trying to figure out the right Speaker

Support forum for the mightyohm.com Geiger Counter.
http://mightyohm.com/geiger
Post Reply
ebaugh
Posts: 3
Joined: Mon Nov 18, 2019 11:41 am

Trying to figure out the right Speaker

Post by ebaugh » Mon Nov 18, 2019 11:47 am

Ok, I've tried two different speaker parts but neither seem to be the right one (at least in terms of how they fit)
Can I get a part # for the speaker so I don't keep adding to my collection of parts? :-)

An Amazon link would be fine...

Thanks
Earl

User avatar
mightyohm
Site Admin
Posts: 1007
Joined: Fri Apr 03, 2009 10:29 pm
Location: Seattle, WA
Contact:

Re: Trying to figure out the right Speaker

Post by mightyohm » Mon Nov 18, 2019 2:31 pm

Earl,

A piezo speaker should have been included in your kit. Where did you purchase the kit?

ebaugh
Posts: 3
Joined: Mon Nov 18, 2019 11:41 am

Re: Trying to figure out the right Speaker

Post by ebaugh » Tue Nov 26, 2019 9:57 am

I bought the board from you directly.
I had 99% of the parts sitting around here so I just ordered a board.... but of course, none of the speakers handy have the
right pin spacing to fit your board. Didn't see a clear spec on the part so the ask.

(I just built and Adafruit USBtinyISP AVR to programm the chip today... so getting close... just need to find one cap and the speaker..)

Earl

User avatar
mightyohm
Site Admin
Posts: 1007
Joined: Fri Apr 03, 2009 10:29 pm
Location: Seattle, WA
Contact:

Re: Trying to figure out the right Speaker

Post by mightyohm » Tue Dec 03, 2019 10:20 am

Earl -

Sorry for the late reply, I've been traveling these past few days.

The speaker is TDK PS1740P02E. Other piezo speakers with similar pin spacing (10mm) should also work!

Post Reply