Hangs on entering fuse values
Posted: Mon Aug 01, 2022 11:31 am
Hello - I am trying to reset the fuses on what I believe is a clone 328p. It's in a QFN28 package, and I have an adapter & jumper cables to connect the pins to the DIP socket. Per the datasheet, I had to move the pins as the number to function assignment are not the same (they're offset by 4 pins).
When programming, I get as far as entering the desired lfuse value, and then it just hangs.
Sketch Version 212, arduino 1.8.19.
Thanks,
Derek
When programming, I get as far as entering the desired lfuse value, and then it just hangs.
Sketch Version 212, arduino 1.8.19.
Code: Select all
Select mode:
1: ATmega (28-pin)
2: ATtiny2313
3: ATtiny (8-pin) / HVSP
Selected mode: ATMEGA
Insert target AVR and press button.
Existing fuse values:
LFUSE: 0
HFUSE: 0
EFUSE: 0
Enter desired LFUSE hex value (ie. 0x62):
Derek