Page 1 of 1


Posted: Sat Nov 23, 2013 12:19 pm
by mdn15
I cannot seem to get the HV Rescue Shield 2.1 to work with the MEGA ADK. Is it incompatible. it has the same processer as the Arduino Mega?

More specifically, I can load the Sketch (and yes I have modified the flags to say that Im using a Mega), but I cannot get interactive or automatic modes to work.

Any advice or help would be greatly appreciated.



Posted: Sun Dec 08, 2013 10:19 pm
by mightyohm
Do you have the Rescue Shield installed as shown here? ... uino-mega/

Do you have a regular Mega or Uno around that you can test with to make sure your Rescue Shield is working?

Also, double-check the baud rate setting in the serial monitor. It should be set to 9600 baud.