Hi folks. I love this HV rescue shield; it has saved my butt many times
Is there a way to set/change the device signature? I have an atmega328 that is reporting it's device signature as "0x5E 0xD7 0x54". I'd like to change that to the proper signature, 1E 95 14. The chip may be damaged, but I'd like to try changing the signature before I chuck it in the trash.
Thanks!
Seth
Burn device signature?
Re: Burn device signature?
Hi Seth,
As far as I know, it is not possible to change the device signature of the AVR.
As far as I know, it is not possible to change the device signature of the AVR.
Jeff Keyzer
http://mightyohm.com
http://mightyohm.com
Re: Burn device signature?
Ok, but I found this link
http://arduino.stackexchange.com/questi ... i-fix-that
which uses the command line avrdude program and it looks like they were able to do that...but I don't wanna risk using the command line and doing something wrong...
Could somebody use that information and tweak the HV rescue shield program to allow changing those signature bytes?
http://arduino.stackexchange.com/questi ... i-fix-that
which uses the command line avrdude program and it looks like they were able to do that...but I don't wanna risk using the command line and doing something wrong...
Could somebody use that information and tweak the HV rescue shield program to allow changing those signature bytes?
Re: Burn device signature?
Oops, apparently I missed the part about it not actually being writeable...apparently that address is read-only...
well, looks like I have a dud 328 then...
well, looks like I have a dud 328 then...
Re: Burn device signature?
You are correct, those bits are read only. Sorry about that.
Jeff Keyzer
http://mightyohm.com
http://mightyohm.com